If RF Module P/N DGAU-0046 is installed the following approvals apply:
RF Module Agency Certifications
United States (FCC)
Contains FCC ID : VW4A091732.
This equipment complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation (FCC 15.19).
Modifications not expressly approved by this company could void the user＊s authority to operate this equipment (FCC section 15.21).
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense (FCC section 15.105).
Industry Canada (IC)
Contains IC: 11019A-091732
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
FR Le présent appareil est conforme aux CNR d＊Industrie Canada applicables aux appareils radio exempts de licence. L＊exploitation est autorisée aux deux conditions suivantes : (1) l＊appareil ne doit pas produire de brouillage, et (2) l＊utilisateur de l＊appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d＊en compromettre le fonctionnement.
This equipment complies with radio frequency exposure limits set forth by Industry Canada for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the device and the user or bystanders.
FR Cet équipement est conforme aux limites d＊exposition aux radiofréquences définies par Industrie Canada pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre le dispositif et l＊utilisateur ou des tiers
European Union (ETSI)
The RF Module Radio has been certified for use in the European Union countries and conforms to the low voltage directives and safety directives.